Chapter 12
| Security Measures
DHCP Snooping
– 387 –
◆ Store – Writes all dynamically learned snooping entries to flash memory. This
function can be used to store the currently learned dynamic DHCP snooping
entries to flash memory. These entries will be restored to the snooping table
when the switch is reset. However, note that the lease time shown for a
dynamic entry that has been restored from flash memory will no longer be
valid.
◆ Clear – Removes all dynamically learned snooping entries from flash memory.
Web Interface
To display the binding table for DHCP Snooping:
1. Click IP Service, DHCP, Snooping.
2. Select Show Information from the Step list.
3. Use the Store or Clear function if required.
Figure 236: Displaying the Binding Table for DHCP Snooping
To Next Page
Loading...
