Figures
– 23 –
Figure 65: Configuring Members for Traffic Segmentation 158
Figure 66: Showing Traffic Segmentation Members 159
Figure 67: Configuring VLAN Trunking 159
Figure 68: Configuring VLAN Trunking 161
Figure 69: VLAN Compliant and VLAN Non-compliant Devices 164
Figure 70: Using GVRP 166
Figure 71: Creating Static VLANs 168
Figure 72: Modifying Settings for Static VLANs 168
Figure 73: Showing Static VLANs 169
Figure 74: Configuring Static Members by VLAN Index 172
Figure 75: Configuring Static VLAN Members by Interface 172
Figure 76: Configuring Static VLAN Members by Interface Range 173
Figure 77: Configuring Global Status of GVRP 175
Figure 78: Configuring GVRP for an Interface 175
Figure 79: Showing Dynamic VLANs Registered on the Switch 176
Figure 80: Showing the Members of a Dynamic VLAN 176
Figure 81: QinQ Operational Concept 178
Figure 82: Enabling QinQ Tunneling 182
Figure 83: Configuring CVLAN to SPVLAN Mapping Entries 183
Figure 84: Showing CVLAN to SPVLAN Mapping Entries 183
Figure 85: Adding an Interface to a QinQ Tunnel 185
Figure 86: Configuring Protocol VLANs 187
Figure 87: Displaying Protocol VLANs 187
Figure 88: Assigning Interfaces to Protocol VLANs 189
Figure 89: Showing the Interface to Protocol Group Mapping 189
Figure 90: Configuring IP Subnet VLANs 191
Figure 91: Showing IP Subnet VLANs 191
Figure 92: Configuring MAC-Based VLANs 192
Figure 93: Showing MAC-Based VLANs 193
Figure 94: Configuring VLAN Mirroring 194
Figure 95: Showing the VLANs to Mirror 194
Figure 96: Configuring VLAN Translation 195
Figure 97: Configuring VLAN Translation 196
Figure 98: Showing the Entries for VLAN Translation 196
Figure 99: Configuring MAC Address Learning 198
To Next Page
Loading...
Need help?
General