Figures
– 24 –
Figure 100: Configuring Static MAC Addresses 200
Figure 101: Displaying Static MAC Addresses 200
Figure 102: Setting the Address Aging Time 201
Figure 103: Displaying the Dynamic MAC Address Table 202
Figure 104: Clearing Entries in the Dynamic MAC Address Table 203
Figure 105: Mirroring Packets Based on the Source MAC Address 205
Figure 106: Showing the Source MAC Addresses to Mirror 205
Figure 107: Issuing MAC Address Traps (Global Configuration) 206
Figure 108: Issuing MAC Address Traps (Interface Configuration) 206
Figure 109: STP Root Ports and Designated Ports 208
Figure 110: MSTP Region, Internal Spanning Tree, Multiple Spanning Tree 208
Figure 111: Spanning Tree – Common Internal, Common, Internal 209
Figure 112: Configuring Port Loopback Detection 211
Figure 113: Configuring Global Settings for STA (STP) 215
Figure 114: Configuring Global Settings for STA (RSTP) 215
Figure 115: Configuring Global Settings for STA (MSTP) 216
Figure 116: Displaying Global Settings for STA 217
Figure 117: Configuring Interface Settings for STA 221
Figure 118: STA Port Roles 223
Figure 119: Displaying Interface Settings for STA 223
Figure 120: Creating an MST Instance 225
Figure 121: Displaying MST Instances 225
Figure 122: Modifying the Priority for an MST Instance 226
Figure 123: Displaying Global Settings for an MST Instance 226
Figure 124: Adding a VLAN to an MST Instance 227
Figure 125: Displaying Members of an MST Instance 227
Figure 126: Configuring MSTP Interface Settings 229
Figure 127: Displaying MSTP Interface Settings 229
Figure 128: Configuring Rate Limits 232
Figure 129: Configuring Storm Control 234
Figure 130: Storm Control by Limiting the Traffic Rate 234
Figure 131: Storm Control by Shutting Down a Port 235
Figure 132: Configuring ATC Timers 237
Figure 133: Configuring ATC Interface Attributes 239
Figure 134: Setting the Default Port Priority 242
To Next Page
Loading...
Need help?
General