Chapter 4
| System Management Commands
Stacking
– 197 –
Provision complete ...
Finished module 2 provision complete ...
Module provision complete.
switch stacking
button
This command sets the front panel 10G ports to stacking mode. Use the no form to
disable this function.
Syntax
[no] switch stacking button
Default Setting
Disabled
Command Mode
Privileged Exec
Command Usage
◆ Use this command on all stack members.
◆ Use the switch master button command to specify one unit as the stack master.
◆ Every switch in the stack must be rebooted to activate this command. Note that
the configured setting is not affected by changes to the start-up configuration
file.
Example
Console#switch stacking button
Console#
show switch master
button
This command shows the status of the master button.
Command Mode
Privileged Exec
Command Usage
◆ If the stack has not been initialized, “N” will be displayed in the switch ID field.
◆ Use the switch master button command to specify one unit as the stack master.
Example
Console#show switch master button
Switch ID Master-button-pressed
--------- ---------------------
1 Y
2 N
Console#
To Next Page
Loading...
Need help?
General