Chapter 8
| Authentication Commands
802.1X Port Authentication
– 280 –
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-reauth-req 2
Console(config-if)#
dot1x max-req This command sets the maximum number of times the switch port will retransmit
an EAP request/identity packet to the client before it times out the authentication
session. Use the no form to restore the default.
Syntax
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#
dot1x
operation-mode
This command allows hosts (clients) to connect to an 802.1X-authorized port. Use
the no form with no keywords to restore the default to single host. Use the no form
with the multi-host max-count keywords to restore the default maximum count.
Syntax
dot1x operation-mode {single-host | multi-host [max-count count] | mac-
based-auth}
no dot1x operation-mode [multi-host max-count]
single-host – Allows only a single host to connect to this port.
multi-host – Allows multiple host to connect to this port.
max-count – Keyword for the maximum number of hosts.
count – The maximum number of hosts that can connect to a port.
(Range: 1-1024; Default: 5)
mac-based – Allows multiple hosts to connect to this port, with each host
needing to be authenticated.
To Next Page
Loading...
Need help?
General