Chapter 8
| Authentication Commands
802.1X Port Authentication
– 287 –
â—† A port cannot be configured as a dot1x supplicant if it is a member of a trunk or
LACP is enabled on the port.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#dot1x pae supplicant
Console(config-if)#
dot1x timeout
auth-period
This command sets the time that a supplicant port waits for a response from the
authenticator. Use the no form to restore the default setting.
Syntax
dot1x timeout auth-period seconds
no dot1x timeout auth-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Command Usage
This command sets the time that the supplicant waits for a response from the
authenticator for packets other than EAPOL-Start.
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout auth-period 60
Console(config-if)#
dot1x timeout
held-period
This command sets the time that a supplicant port waits before resending its
credentials to find a new an authenticator. Use the no form to reset the default.
Syntax
dot1x timeout held-period seconds
no dot1x timeout held-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
To Next Page
Loading...
Need help?
General