Chapter 10
| Access Control Lists
MAC ACLs
– 402 –
{ipv6 {any | host source-ipv6 | source-ipv6/prefix-length}
{any | host destination-ipv6 | destination-ipv6/prefix-length}}
[protocol protocol]
[l4-source-port sport [port-bitmask]]
[l4-destination-port dport [port-bitmask]}]
[time-range time-range-name]
no {permit | deny}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype ethertype [ethertype-bitmask]]
{{ip {any | host source-ip | source-ip network-mask}
{any | host destination-ip | destination-ip network-mask}
{ipv6 {any | host source-ipv6 | so
urce-ipv6/prefix-length}
{any | host destination-ipv6 | destination-ipv6/prefix-length}}
[protocol protocol]
[l4-source-port sport [port-bitmask]]
[l4-destination-port dport [port-bitmask]}]
Note:
The default is for Ethernet II packets.
{permit | deny} tagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype ethertype [ethertype-bitmask]]
{{ip {any | host source-ip | source-ip network-mask}
{any | host destination-ip | destination-ip network-mask}
{ipv6 {any | host source-ipv6 | source-ipv6/prefix-length}
{any | host destination-ipv6 | destination-ipv6/prefix-length}}
[protocol protocol]
[l4-source-port sport [port-bitmask]]
[l4-destination-port dport [port-bitmask]}]
[time-range time-range-name]
no {permit | deny} tagged-eth2
{an
y | ho
st source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype ethertype [ethertype-bitmask]]
{{ip {any | host source-ip | source-ip network-mask}
{any | host destination-ip | destination-ip network-mask}
{ipv6 {any | host source-ipv6 | source-ipv6/prefix-length}
{any | host destination-ipv6 | destination-ipv6/prefix-length}}
[protocol protocol]
[l4-source-port sport [port-bitmask]]
[l4-destination-port dport [port-bitmask]}]
To Next Page
Loading...
Need help?
General