Chapter 16
| Loopback Detection Commands
– 495 –
Default Setting
None
Command Mode
Global Configuration
Command Usage
Refer to the loopback-detection recover-time command for information on
conditions which constitute loopback recovery.
Example
Console(config)#loopback-detection trap both
Console(config)#
loopback-detection
release
This command releases all interfaces currently shut down by the loopback
detection feature.
Syntax
loopback-detection release
Command Mode
Privileged Exec
Example
Console#loopback-detection release
Console(config)#
show loopback-
detection
This command shows loopback detection configuration settings for the switch or
for a specified interface.
Syntax
show loopback-detection [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General