Chapter 23
| Quality of Service Commands
– 651 –
service-policy This command applies a policy map defined by the policy-map command to the
ingress or egress side of a particular interface. Use the no form to remove this
mapping.
Syntax
[no] service-policy {input | output} policy-map-name
input
- Apply to the input traffic.
output
- Apply to the output traffic.
policy-map-name
- Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—† Only one policy map can be assigned to an interface.
â—† First define a class map, then define a policy map, and finally use the service-
policy command to bind the policy map to the required interface.
Example
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#
show class-map This command displays the QoS class maps which define matching criteria used for
classifying traffic.
Syntax
show class-map [class-map-name]
class-map-name - Name of the class map. (Range: 1-32 characters)
Default Setting
Displays all class maps.
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General