Contents
– 9 –
Displaying Transceiver Data 133
Configuring Transceiver Thresholds 134
Performing Cable Diagnostics 136
Trunk Configuration 138
Configuring a Static Trunk 139
Configuring a Dynamic Trunk 142
Displaying LACP Port Counters 148
Displaying LACP Settings and Status for the Local Side 149
Displaying LACP Settings and Status for the Remote Side 151
Configuring Load Balancing 152
Saving Power 154
Traffic Segmentation 156
Enabling Traffic Segmentation 156
Configuring Uplink and Downlink Ports 157
VLAN Trunking 159
5 VLAN Configuration 163
IEEE 802.1Q VLANs 163
Configuring VLAN Groups 166
Adding Static Members to VLANs 169
Configuring Dynamic VLAN Registration 173
IEEE 802.1Q Tunneling 177
Enabling QinQ Tunneling on the Switch 181
Creating CVLAN to SPVLAN Mapping Entries 182
Adding an Interface to a QinQ Tunnel 184
Protocol VLANs 185
Configuring Protocol VLAN Groups 186
Mapping Protocol Groups to Interfaces 187
Configuring IP Subnet VLANs 189
Configuring MAC-based VLANs 191
Configuring VLAN Mirroring 193
Configuring VLAN Translation 195
6 Address Table Settings 197
Configuring MAC Address Learning 197
Setting Static Addresses 199
To Next Page
Loading...
Need help?
General