Chapter 24
| Multicast Filtering Commands
MLD Snooping
– 700 –
Command Usage
This command only clears entries learned though MLD snooping. Statically
configured multicast address are not cleared.
Example
Console#clear ipv6 mld snooping groups dynamic
Console#
clear ipv6 mld
snooping statistics
This command clears MLD snooping statistics.
Syntax
clear ipv6 mld snooping statistics [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
vlan vlan-id - VLAN identifier (Range: 1-4094)
Command Mode
Privileged Exec
Example
Console#clear ipv6 mld snooping statistics
Console#
show ipv6
mld snooping
This command shows the current MLD Snooping configuration.
Syntax
show ipv6 mld snooping
Command Mode
Privileged Exec
Example
The following shows MLD Snooping configuration information
Console#show ipv6 mld snooping
Service Status : Disabled
Querier Status : Disabled
Robustness : 2
Query Interval : 125 sec
To Next Page
Loading...
Need help?
General