Chapter 24
| Multicast Filtering Commands
IGMP (Layer 3)
– 753 –
IGMP (Layer 3)
This section describes commands used to configure Layer 3 Internet Group
Management Protocol (IGMP) on the switch.
Table 148: show mvr6 statistics query - display description
Field Description
Other Querier Address The IPv6 address of the querier on this interface.
Other Querier Uptime Other querier’s time up.
Other Querier Expire Time The time after which this querier is assumed to have expired.
Self Querier Address This querier’s IPv6 address.
Self Querier Uptime This querier’s time up.
Self Querier Expire Time This querier’s expire time.
General Query Received The number of general queries received on this interface.
General Query Sent The number of general queries sent from this interface.
Specific Query Received The number of specific queries received on this interface.
Specific Query Sent The number of specific queries sent from this interface.
Table 149: IGMP Commands (Layer 3)
Command Function Mode
ip igmp Enables IGMP for the specified interface IC
ip igmp last-member-
query-interval
Configures the frequency at which to send query messages
in response to receiving a leave message
IC
ip igmp max-resp-interval Configures the maximum host response time IC
ip igmp query-interval Configures frequency for sending host query messages IC
ip igmp robustval Configures the expected packet loss IC
ip igmp static-group Configures the router to be a static member of a multicast
group on the specified VLAN interface
IC
ip igmp version Configures IGMP version used on this interface IC
clear ip igmp group Deletes entries from the IGMP cache PE
show ip igmp groups Displays information for IGMP groups PE
show ip igmp interface Displays multicast information for the specified interface PE
To Next Page
Loading...
Need help?
General