Chapter 25
| LLDP Commands
– 793 –
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—† This command only applies to the ECS4510-28P/52P.
This option advertises extended Power-over-Ethernet capability details, such as
power availability from the switch, and power state of the switch, including
whether the switch is operating from primary or backup power (the Endpoint
Device could use this information to decide to enter power conservation mode).
Note that this device does not support PoE capabilities.
â—†
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp med-tlv ext-poe
Console(config-if)#
lldp med-tlv inventory This command configures an LLDP-MED-enabled port to advertise its inventory
identification details. Use the no form to disable this feature.
Syntax
[no] lldp med-tlv inventory
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises device details useful for inventory management, such as
manufacturer, model, software version and other pertinent information.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp med-tlv inventory
Console(config-if)#
lldp med-tlv location This command configures an LLDP-MED-enabled port to advertise its location
identification details. Use the no form to disable this feature.
Syntax
[no] lldp med-tlv location
To Next Page
Loading...
Need help?
General