Chapter 50
| IP Routing Commands
Routing Information Protocol (RIP)
– 974 –
Example
This example redistributes routes learned from OSPF and sets the metric for all
external routes imported from OSPF to a value of 3.
Console(config-router)#redistribute ospf metric 3
Console(config-router)#
This example redistributes static routes and sets the metric for all of these routes to
a value of 3.
Console(config-router)#redistribute static metric 3
Console(config-router)#
Related Commands
default-metric (968)
timers basic This command configures the RIP update timer, timeout timer, and garbage-
collection timer. Use the no form to restore the defaults.
Syntax
timers basic update timeout garbage
no timers basic
update – Sets the update timer to the specified value.
(Range: 5-2147483647 seconds)
timeout – Sets the timeout timer to the specified value. (Range: 90-360
seconds)
garbage – Sets the garbage collection timer to the specified value.
(Range: 60-240 seconds)
Default Setting
Update: 30 seconds
Timeout: 180 seconds
Garbage collection: 120 seconds
Command Mode
Router Configuration
Command Usage
◆ The update timer sets the rate at which updates are sent. This is the
fundamental timer used to control all basic RIP processes.
◆ The timeout timer is the time after which there have been no update messages
that a route is declared dead. The route is marked inaccessible (i.e., the metric
To Next Page
Loading...
