Figures
ā 34 ā
Figure 450: Configuring Static Routes 683
Figure 451: Displaying Static Routes 683
Figure 452: Displaying the Routing Table 685
Figure 453: Setting the Maximum ECMP Number 686
Figure 454: Master Virtual Router with Backup Routers 687
Figure 455: Several Virtual Master Routers Using Backup Routers 688
Figure 456: Several Virtual Master Routers Configured for Mutual Backup and Load Sharing 688
Figure 457: Configuring the VRRP Group ID 692
Figure 458: Showing Configured VRRP Groups 692
Figure 459: Setting the Virtual Router Address for a VRRP Group 693
Figure 460: Showing the Virtual Addresses Assigned to VRRP Groups 693
Figure 461: Configuring Detailed Settings for a VRRP Group 694
Figure 462: Showing Counters for Errors Found in VRRP Packets 695
Figure 463: Showing Counters for Errors Found in a VRRP Group 696
Figure 464: Configuring RIP 698
Figure 465: Configuring General Settings for RIP 702
Figure 466: Clearing Entries from the Routing Table 703
Figure 467: Adding Network Interfaces to RIP 704
Figure 468: Showing Network Interfaces Using RIP 705
Figure 469: Specifying a Passive RIP Interface 706
Figure 470: Showing Passive RIP Interfaces 706
Figure 471: Specifying a Static RIP Neighbor 707
Figure 472: Showing Static RIP Neighbors 707
Figure 473: Redistributing External Routes into RIP 708
Figure 474: Showing External Routes Redistributed into RIP 709
Figure 475: Setting the Distance Assigned to External Routes 710
Figure 476: Showing the Distance Assigned to External Routes 710
Figure 477: Configuring a Network Interface for RIP 713
Figure 478: Showing RIP Network Interface Settings 714
Figure 479: Showing RIP Interface Settings 714
Figure 480: Showing RIP Peer Information 715
Figure 481: Resetting RIP Statistics 716
Figure 482: Configuring OSPF 716
Figure 483: OSPF Areas 718
Figure 484: Defining OSPF Network Areas Based on Addresses 719
To Next Page
Loading...
