EasyManuals Logo

Edge-Core ECS4620-28T User Manual

Edge-Core ECS4620-28T
2143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #436 background imageLoading...
Page #436 background image
Chapter 13
| Basic Administration Protocols
Simple Network Management Protocol
– 430 –
Private Traps
swPowerStatusChangeTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.1 This trap is sent when the power state changes.
swPortSecurityTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.36 This trap is sent when the port is being intruded.
This trap will only be sent when the
portSecActionTrap is enabled.
swIpFilterRejectTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.40 This trap is sent when an incorrect IP address is
rejected by the IP Filter.
swAtcBcastStormAlarmFireTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.70 When broadcast traffic is detected as a storm, this
trap is fired.
swAtcBcastStormAlarmClearTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.71 When a broadcast storm is detected as normal
traffic, this trap is fired.
swAtcBcastStormTcApplyTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.72 When ATC is activated, this trap is fired.
swAtcBcastStormTcReleaseTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.73 When ATC is released, this trap is fired.
swAtcMcastStormAlarmFireTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.74 When multicast traffic is detected as the storm, this
trap is fired.
swAtcMcastStormAlarmClearTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.75 When multicast storm is detected as normal traffic,
this trap is fired.
swAtcMcastStormTcApplyTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.76 When ATC is activated, this trap is fired.
swAtcMcastStormTcReleaseTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.77 When ATC is released, this trap is fired.
stpBpduGuardPortShutdownTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.91 This trap will be sent when an interface is shut down
because of BPDU guard.
swLoopbackDetectionTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.95 This trap is sent when loopback BPDUs have been
detected.
networkAccessPortLinkDetectionTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.96 This trap is sent when a
networkAccessPortLinkDetection event is
triggered.
dot1agCfmMepUpTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.97 This trap is sent when a new remote MEP is
discovered.
dot1agCfmMepDownTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.98 This trap is sent when port status or interface status
TLV received from remote MEP indicates it is not up.
dot1agCfmConfigFailTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.99 This trap is sent when a MEP receives a CCM with
MPID which already exists on the same MA in this
switch.
dot1agCfmLoopFindTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.100 This trap is sent when a MEP receives its own CCMs.
dot1agCfmMepUnknownTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.101 This trap is sent when a CCM is received from an
unexpected MEP.
dot1agCfmMepMissingTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.102 This trap is sent when the cross-check enable timer
expires and no CCMs were received from an
expected (configured) MEP.
dot1agCfmMaUpTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.103 This trap is sent when all expected remote MEPs are
up.
autoUpgradeTrap 1.3.6.1.4.1.259.10.1.41.2.1.0.104 This trap is sent when auto upgrade is executed.
Table 29: Supported Notification Messages (Continued)
Model Level Group

Table of Contents

Other manuals for Edge-Core ECS4620-28T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4620-28T and is the answer not in the manual?

Edge-Core ECS4620-28T Specifications

General IconGeneral
BrandEdge-Core
ModelECS4620-28T
CategorySwitch
LanguageEnglish

Related product manuals