Chapter 13
| Basic Administration Protocols
Simple Network Management Protocol
– 438 –
■
AuthPriv – SNMP communications use both authentication and
encryption.
◆ Authentication Protocol – The method used for user authentication.
(Options: MD5, SHA; Default: MD5)
◆ Authentication Password – A minimum of eight plain text characters is
required.
◆ Privacy Protocol – The encryption algorithm use for data privacy; only 56-bit
DES is currently available.
◆ Privacy Password – A minimum of eight plain text characters is required.
Web Interface
To configure a remote SNMPv3 user:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Add SNMPv3 Remote User from the Action list.
4. Enter a name and assign it to a group. Enter the IP address to identify the source
of SNMPv3 inform messages sent from the local switch. If the security model is
set to SNMPv3 and the security level is authNoPriv or authPriv, then an
authentication protocol and password must be specified. If the security level is
authPriv, a privacy password must also be specified.
5. Click Apply
To Next Page
Loading...
