Chapter 13
| Basic Administration Protocols
Connectivity Fault Management
– 515 –
Displaying Details
for Local MEPs
Use the Administration > CFM > Show Information (Show Local MEP Details) page
to show detailed CFM information about a local MEP in the continuity check
database.
Parameters
These parameters are displayed:
◆ MD Index – Domain index. (Range: 1-65535)
◆ MA Index – MA identifier. (Range: 1-2147483647)
◆ MEP ID – Maintenance end point identifier. (Range: 1-8191)
◆ MD Name – The maintenance domain for this entry.
◆ MA Name – Maintenance association to which this remote MEP belongs.
◆ MA Name Format – The format of the Maintenance Association name,
including
Character String or ICC Based.
◆ Level – Maintenance level of the local maintenance point.
◆ Direction – The direction in which the MEP faces on the Bridge port (up or
down).
◆ Interface – The port to which this MEP is attached.
◆ CC Status – Shows if the MEP will generate CCM messages.
◆ MAC Address – MAC address of the local maintenance point. (If a CCM for the
specified remote MEP has never been received or the local MEP record times
out, the address will be set to the initial value of all Fs.)
◆ Defect Condition – Shows the defect detected on the MEP.
◆ Received RDI – Receive status of remote defect indication (RDI) messages on
the MEP.
◆ AIS Status – Shows if MEPs within the specified MA are enabled to send frames
with AIS information following detection of defect conditions.
◆ AIS Period – The interval at which AIS information is sent.
◆ AIS Transmit Level – The maintenance level at which AIS information will be
sent for the specified MEP.
◆ Suppress Alarm – Shows if the specified MEP is configured to suppress
sending frames containing AIS information following the detection of defect
conditions.
To Next Page
Loading...
Need help?
General