Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 64 –
Priority
Default Priority Sets the default priority for each port or trunk 241
Queue Sets queue mode for the switch; sets the service weight for each queue
that will use a weighted or hybrid mode
242
Trust Mode Selects DSCP or CoS priority processing 248
DSCP to DSCP 249
Add Maps DSCP values in incoming packets to per-hop behavior and drop
precedence values for internal priority processing
249
Show Shows the DSCP to DSCP mapping list 249
CoS to DSCP 252
Add Maps CoS/CFI values in incoming packets to per-hop behavior and drop
precedence values for priority processing
252
Show Shows the CoS to DSCP mapping list 252
PHB to Queue 245
Add Maps internal per-hop behavior values to hardware queues 245
Show Shows the PHB to Queue mapping list 245
DiffServ 255
Configure Class 256
Add Creates a class map for a type of traffic 256
Show Shows configured class maps 256
Modify Modifies the name of a class map 256
Add Rule Configures the criteria used to classify ingress traffic 256
Show Rule Shows the traffic classification rules for a class map 256
Configure Policy 260
Add Creates a policy map to apply to multiple interfaces 260
Show Shows configured policy maps 260
Modify Modifies the name of a policy map 260
Add Rule Sets the boundary parameters used for monitoring inbound traffic, and
the action to take for conforming and non-conforming traffic
260
Show Rule Shows the rules used to enforce bandwidth policing for a policy map 260
Configure Interface Applies a policy map to an ingress port 269
VoIP Voice over IP 271
Configure Global Configures auto-detection of VoIP traffic, sets the Voice VLAN, and VLAN
aging time
272
Table 4: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General