Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 80 –
Area 725
Configure Area 725
Add Area
Adds NSSA or stub
725
Show Area
Shows configured NSSA or stub
725
Configure NSSA Area
Configures settings for importing routes into or exporting routes
out of not-so-stubby areas
726
Configure Stub Area
Configures default cost, and settings for importing routes into a
stub
729
Show Information
Shows statistics for each area, including SPF startups, ABR/ASBR
count, LSA count, and LSA checksum
731
Area Range 732
Add
Configures route summaries to advertise at an area boundary
732
Show
Shows route summaries advertised at an area boundary
732
Modify
Modifies route summaries advertised at an area boundary
732
Redistribute 734
Add
Redistributes routes from one routing domain to another
734
Show
Shows route types redistributed to another domain
734
Modify
Modifies configuration settings for redistributed routes
734
Summary Address 736
Add
Aggregates routes learned from other protocols for advertising
into other autonomous systems
736
Show
Shows configured summary addresses
736
Interface 738
Show
Shows area ID and designated router settings for each interface
738
Configure by VLAN
Configures OSPF protocol settings and authentication for specified
VLAN
738
Configure by Address
Configures OSPF protocol settings and authentication for specified
interface address
738
Show MD5 Key
Shows MD5 key ID used for each area
738
Virtual Link 743
Add
Configures a virtual link through a transit area to the backbone
743
Show
Shows virtual links, neighbor address, and state
743
Configure Detailed Settings
Configures detailed protocol and authentication settings
743
Show MD5 Key
Shows the MD5 key ID used for each neighbor
743
Information
LSDB
Shows information about different OSPF Link State
Advertisements (LSAs)
746
Neighbor
Shows information about each OSPF neighbor
749
Table 4: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General