Configuring the ECN330-switch
506 1553-KDU 137 365 Uen D 2006-06-16
CLI – The following example configures the router to start advertising itself to the
BSR as a candidate RP for the specified multicast groups.
6.21.5.7 Displaying the Results of the RP Hash
Use the RP Hash page to display the RP elected for the specified multicast
group, the source of this information, and the method of election.
Field Attributes
• Group – IP multicast group address.
• RP Address – Address of the RP responsible for the specified group.
• RP Type – The type can be either BSR or RP.
• Information Source – The device from which information about this RP
entry was obtained, and the method that was used to map this RP to the
specified group.
Console(config)#ip pim rp-candidate vlan 1 224.0.0.0 255.0.0.0
priority 200
Console(config)#exit
Console#show ip pim bsr-router
PIMv2 BootStrap Information:
This system is the BootStrap Router (BSR)
BSR address: 192.168.1.250
BSR priority: 200
BSR hash mask length: 20
Uptime: 0:14:49
Next BootStrap Message in 0:0:16
Candidate BSR: 192.168.1.250 (Vlan1)
Candidate-BSR Priority: 200
Candidate-BSR hash mask length: 20
Candidate RP: 192.168.1.250 (Vlan1)
Candidate-RP Group/masklen: 224.0.0.0/8
Candidate-RP Priority: 200
Next advisement in 0:0:38
Console#
To Next Page
Loading...
