Command Line Interface
576 1553-KDU 137 365 Uen D 2006-06-16
• The timeout for Telnet cannot be disabled.
• Using the command without specifying a timeout restores the default
setting.
Example
To set the timeout to two minutes, enter this command:
7.5.24 password-thresh
Use this command to set the password intrusion threshold which limits the
number of failed logon attempts. Use the no form to remove the threshold value.
Syntax
password-thresh <threshold>
no password-thresh
threshold - The number of allowed password attempts.
(Range: 1-120; 0: no threshold)
Default Setting
The default value is three attempts.
Command Mode
Line Configuration
Command Usage
• When the logon attempt threshold is reached, the system interface
becomes silent for a specified amount of time before allowing the next
logon attempt. (Use the silent-time command to set this interval.)
When this threshold is reached for Telnet, the Telnet logon interface
shuts down.
Console(config-line)#exec-timeout 120
Console(config-line)#
To Next Page
Loading...
