Command Line Interface
578 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
This command only applies to a console port connection, it does not apply
for Telnet connections.
Example
To set the silent time to 60 seconds, enter this command:
Related Commands
password-thresh (section 7.5.24 on page 576)
7.5.26 databits
Use this command to set the number of data bits per character that are
interpreted and generated by the console port. Use the no form to restore the
default value.
Syntax
databits {7 | 8}
no databits
• 7 - Seven data bits per character.
• 8 - Eight data bits per character.
Default Setting
8 data bits per character
Command Mode
Line Configuration
Console(config-line)#silent-time 60
Console(config-line)#
To Next Page
Loading...
