Ericsson ECN330 - Page 585

Command Line Interface
5791553-KDU 137 365 Uen D 2006-06-16
Command Usage
The databits command can be used to mask the high bit on input from
devices that generate 7 data bits with parity. If parity is being generated,
specify 7 data bits per character. If no parity is required, specify 8 data bits
per character.
Example
To specify 7 data bits, enter this command:
Related Commands
parity (section 7.5.27 on page 579)
7.5.27 parity
Use this command to define generation of a parity bit. Use the no form to restore
the default setting.
Syntax
parity {none | even | odd}
no parity
• none - No parity
• even - Even parity
• odd - Odd parity
Default Setting
No parity
Console(config-line)#databits 7
Console(config-line)#