Command Line Interface
8291553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
failtime (section 7.16.4 on page 829)
7.16.4 failtime
This command sets the time the master node waits for a health-check packet
before declaring a break in the ring.
Syntax
failtime <seconds>
seconds - The interval at which the master node sends health-check
packets. (Range: 3-9 seconds)
Default Setting
3 seconds
Command Mode
EAPS Domain Configuration
Command Usage
• The fail time should be set on the master node. Once set, the master
node will send the newly configured fail time to all transit nodes, forcing
each node to update its fail timer. The transit nodes then check for a
health-check packet at the interval specified by the fail time, and report
a link down event to the master node if a health-check packet is not
received during this interval.
Console(config-eaps)#hellotime 2
Console(config-eaps)#
To Next Page
Loading...
