Command Line Interface
8311553-KDU 137 365 Uen D 2006-06-16
Command Mode
EAPS Domain Configuration
Command Usage
• If the ring is complete, the master node prevents a loop by logically
blocking all data traffic in the transmit and receive directions on its
secondary port. If the master node subsequently detects a break in the
ring, it unblocks its secondary port and allows data traffic to be
transmitted and received through it.
• The primary port and secondary port must be removed from an EAPS
domain with the no port command, before specifying a new primary
or secondary port.
Example
7.16.6 control-vlan
This command adds a Control VLAN to an EAPS domain. The Control VLAN is
used only to send and receive EAPS ring maintenance messages. Use the no
form to clear the Control VLAN.
Syntax
[no] control-vlan <vlan-id>
vlan-id - VLAN ID (Range: 1-4094, no leading zeroes)
Default Setting
None
Console(config-eaps)#port primary 25
Console(config-eaps)#port secondary 26
Console(config-eaps)#
To Next Page
Loading...
