Command Line Interface
832 1553-KDU 137 365 Uen D 2006-06-16
Command Mode
EAPS Domain Configuration
Command Usage
• Only one Control VLAN can be configured in an EAPS domain. First
create the VLAN to be used as the Control VLAN (vlan, section 7.17.3
on page 850), add the primary and secondary ring ports as tagged
members to this VLAN (switchport allowed vlan, section 7.17.10
on page 861), and then use the control-vlan command to add the
Control VLAN to the EAPS domain.
• The Control VLAN must not be configured with an IP address. In
addition, only ring ports may be added to the Control VLAN. No other
ports can be members of this VLAN. Also, the ring ports of the CVLAN
must be tagged. Failure to observe these restrictions can result in a loop
in the network.
• Once the domain has been activated with the enable command
(section 7.16.8 on page 834), the configuration of the Control VLAN
cannot be modified. Use the no enable command to stop the EAPS
domain before making any configuration changes to this domain.
Example
Related Commands
protect-vlan (section 7.16.7 on page 833)
Console(config-eaps)#control-vlan 2
Console(config-eaps)#
To Next Page
Loading...
