Command Line Interface
8351553-KDU 137 365 Uen D 2006-06-16
7.16.9 eaps
This command enables EAPS on the ECN330-switch. Use the no form to
disable EAPS.
Syntax
[no] eaps
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
An EAPS domain containing one Control VLAN and one or more Protected
VLANs must be enabled with the enable command (section 7.16.8 on page
834), and the EAPS function enabled on the ECN330-switch with the eaps
command before these domains start running on the ring. Once enabled,
the master node and transit node state machines will start, and the domain
will enter the active state.
Example
Related Commands
enable (section 7.16.8 on page 834)
Console(config)#eaps
Console(config)#
To Next Page
Loading...
