Command Line Interface
9871553-KDU 137 365 Uen D 2006-06-16
Default Setting
None
Command Mode
DHCP Pool Configuration
Command Usage
• If DNS IP servers are not configured for a DHCP client, the client cannot
correlate host names to IP addresses.
• Servers are listed in order of preference (starting with address1 as the
most preferred server).
Example
7.23.12 next-server
This command configures the next server in the boot process of a DHCP client.
Use the no form to remove the boot server list.
Syntax
[no] next-server <address>
address - Specifies the IP address of the next server in the boot
process, which is typically a Trivial File Transfer Protocol (TFTP) server.
Default Setting
None
Command Mode
DHCP Pool Configuration
Console(config-dhcp)#dns-server 10.1.1.253 192.168.3.19
Console(config-dhcp)#
To Next Page
Loading...
