14 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Making Effective Use of This Manual
Contents of This Manual
1-
Chapter 6 “Reading Out Measured Result”
This chapter describes how to read out the measured result and the
measurement signal level monitor result.
Chapter 7 “Sorting Based on Measured Result (Comparator Function)”
This chapter describes how to use the comparator function to perform
sorting based on the measured result.
Chapter 8 “Avoiding Mistakes Related to Work and Daily Checks”
This chapter describes how to avoid simple mistakes related to work, how
to detect the occurrence of an error, and how to execute the self-test.
Chapter 9 “Measurement Applications (Sample Programs)”
This chapter contains sample programs in Excel VBA format for both basic
measurement and measurement using a system integrated with the
handler/scanner interface.
Chapter 10 “Command Reference”
This chapter provides the SCPI command reference for the Keysight
E4981A. Each command is fully described and ordered alphabetically
based on its abbreviated name format. Use the index to look up a SCPI
command by its full syntax. To find a command according to its function,
refer to the “SCPI Command Table” on page 307.
Appendix A “Manual Changes”
This appendix contains the information required to adapt this manual to
earlier versions or configurations of the Keysight E4981A than that
indicated by the current printing date of this manual. The information in
this manual applies directly to the E4981A model that has the serial
number prefix listed on the title page of this manual.
Appendix B “Information for Replacing 4268A, 4288A with E4981A”
This appendix describes information that is applicable when replacing the
Keysight 4268A, 4288A with the Keysight E4981A. See the 4268A, 4288A
Operation Manual for detailed information on the 4268A, 4288A. See the
E4981A Operation Manual and other chapters of this manual
(Programming Manual) for more detailed information on the E4981A.
Appendix C “Status Reporting System”
This appendix describes the status reporting system of the Keysight
E4981A.
Appendix D “Operations when Overload, No Contact, or Low C is Detected”
This appendix describes display output, GPIB/LAN/USB output, and
handler interface output when an Overload, No contact, or Low C is
detected.
To Next Page
Loading...
