Keysight E4981A - Selecting Cable Length; Setting up Averaging Function; Setting up Trigger Delay Time; Setting up Source Delay Time

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 43
Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions
Selecting cable length
To set the cable length (0 m/1 m/2 m), use the following command.
• :CALibration:CABLe[:LENGth] on page 171
Setting up averaging function
Turning ON/OFF averaging function
To turn ON/OFF the averaging function, use the following command.
• [:SENSe]:AVERage[:STATe] on page 233
Setting up averaging count
To set the averaging count, use the following command.
• [:SENSe]:AVERage:COUNt on page 232
Setting up trigger delay time
To set the trigger delay time, use the following command.
• :TRIGger:SEQ2:DELay on page 306
Setting up source delay time
To set the source delay time, use the following command.
• :TRIGger[:SEQ1]:DELay on page 303
Setting trigger sync source
To set the trigger sync source, use the following command.
• :SOURce:VOLTage:MODE on page 269
Setting Signal Level Compensation (SLC)
To set the signal level compensation (SLC), use the following command.
• :SOURce:VOLTage:ALC[:STATe] on page 267
Sample program
See Example 9-1 to view an example of setting up measurement conditions
and LCD display.