Keysight E4981A - Sorting Based on Measured Result (Comparator Function); Setting up Comparator Function; Turning ON;OFF Comparator Function; Setting up Limit Range

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Programming Manual
7 Sorting Based on Measured Result (Comparator
Function)
This chapter describes how to use the comparator function to perform sorting
based on the measured result.
Setting Up Comparator Function
Turning ON/OFF comparator function
To enable/disable the comparator function, use the following command:
• :CALCulate1:COMParator[:STATe] on page 187
Setting up limit range
Clearing (resetting) limit range
You can clear the ON/OFF state and the lower and upper limit values of all limit
ranges (BIN1 to BIN9 and the secondary parameter limit range) and the
ON/OFF state of AUX BIN to recover the factory-shipped default values (refer
to Operation Manual, Appendix C “Initial Setting”).
To clear the limit ranges, use the following command.
• :CALCulate1:COMParator:CLEar on page 175