Keysight E4981A - Setting up Measurement Signal (Frequency and Level); Selecting Measurement Range; Selecting Measurement Time

42 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions
3-
G: Equivalent parallel conductance measured using the parallel
equivalent circuit model
Rp: Equivalent parallel resistance measured using the parallel
equivalent circuit model
Rs: Equivalent series resistance measured using the series
equivalent circuit model
Setting up measurement signal (frequency and level)
Setting up frequency
To select the measurement signal frequency (120 Hz/1 kHz/1 MHz), use the
following command.
• :SOURce:FREQuency[:CW] on page 267
Setting up level
To set the measurement signal level, use the following command.
• :SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude] on page 268
Selecting measurement range
Selecting measurement range mode
To select the measurement range mode (auto range/hold range), use the
following command.
• [:SENSe][:FIMPedance]:RANGe:AUTO on page 265
Selecting measurement range
To select the measurement range, use the following command.
• [:SENSe][:FIMPedance]:RANGe[:UPPer] on page 266
The selectable measurement ranges differ depending on the measurement
signal frequency. Therefore, if a newly selected measurement frequency
conflicts with the current measurement range setting, the setting
automatically changes to cover the allowable range.
Selecting measurement time
To select the measurement time (1,2,4,6,8), use the following command.
• [:SENSe][:FIMPedance]:APERture:TIME on page 253
Setting up the measurement range automatically sets up the measurement
range mode to the hold range mode.