Keysight E4981A Programming Manual

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 303
Command Reference
E4981A SCPI Commands
:TRIGger[:SEQ1]:DELay
Syntax :TRIGger[:SEQ1]:DELay <numeric>[mS|S]
:TRIGger[:SEQ1]:DELay?
Description Specifies the waiting time between when a trigger is inputted and when the
measurement signal is outputted (source delay time). The source delay time is
valid only when the synchronous source function is enabled (SYNC, with the
:SOURce:VOLTage:MODE on page 269).
Parameters
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
Query response {numeric}<newline><^END>
Equivalent key
sequence
[Meas Setup] - SRC DLY
<numeric>
Description Source delay time
Range 0 to 1
Initial value 0
Unit s (second)
Resolution 100u
A fraction below the resolution is rounded off. MAX or MIN can be used to
specify the parameters.

Keysight E4981A Specifications

General

Brand	Keysight
Model	E4981A
Category	Measuring Instruments
Language	English