Keysight E4981A - Data:feed:buf2

196 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:DATA:FEED:BUF2
Syntax :DATA:FEED:BUF2 {“CALCulate1”|”CALCulate2”|””}
:DATA:FEED:BUF2?
Description Selects the measurement data fed into data buffer 2from the following: primary
parameter, secondary parameter, or none to be fed. The query response is a
string with double quotation marks (“).
Parameters
Query response {"CALCulate1"|"CALCulate2"|""}<newline><^END>
Related commands :DATA:FEED:CONTrol[:STATe] on page 200
:DATA:POINts:BUF1 on page 202
Equivalent key
sequence
No equivalent key is available on the front panel.
The functionality of this command is same as :DATA:FEED[:SOURce] with
value of BUF2.
Description
“CALCulate1” Specifies the primary parameter as the measurement data fed into
the data buffer 2.
“CALCulate2” Specifies the secondary parameter as the measurement data fed
into the data buffer 2.
““ (initial value) Does not feed the measurement data into the data buffer 2.