Keysight E4981A - Data:reference1:Data

206 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:DATA:REFerence1:DATA
Syntax :DATA:REFerence1:DATA <numeric>
:DATA:REFerence1:DATA?
Description Sets or reads out the reference value for the primary parameter used in the
deviation measurement mode.
Parameters
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
Query response {numeric}<newline><^END>
Related commands :DATA:REFerence2:DATA on page 207
Equivalent key
sequence
[Meas Setup] - REF A or B
The functionality of this command is same as :DATA[:DATA] with value of
REF1.
<numeric>
Range -99.9999E9 to 99.9999E9
Initial value 0