Keysight E4981A - Reading out Measured Result; Data Transfer Format

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Programming Manual
6 Reading Out Measured Result
This chapter describes how to read out the measured result and the
measurement signal level monitor result.
Data Transfer Format
You can select either the ASCII transfer format or binary transfer format when
transferring data with the following commands:
The ASCII transfer format is always used when transferring data with
commands other than those listed below:
• :FETCh? on page 220
• :READ? on page 230
• *TRG on page 163
• :DATA[:DATA] on page 208
• [:SENSe]:CORRection:DATA on page 240
• [:SENSe][:FIMPedance]:CONTact1:VERify:BUF1:DATA? on page 253
• [:SENSe][:FIMPedance]:CONTact1:VERify:BUF2:DATA? on page 256
To set up the data transfer format, use the following command:
• :FORMat[:DATA] on page 225