Keysight E4981A - [:Sense]:Correction:ckit:stan3[:Data]

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 235
Command Reference
E4981A SCPI Commands
[:SENSe]:CORRection:CKIT:STAN3[:DATA]
Syntax [:SENSe]:CORRection:CKIT:STAN3[:DATA] <numeric 1>,<numeric 2>
[:SENSe]:CORRection:CKIT:STAN3[:DATA]?
Description Defines the values of the LOAD correction standard for the parameters you
specify by using the [:SENSe]:CORRection:CKIT:STAN3:FORMat command.
These are set as the standard values for the measurement frequency when
executing the command (set with the :SOURce:FREQuency[:CW] command).
When using the multi-correction function (set to ON with the
[:SENSe]:CORRection:MULTiple[:STATe] command) with the
channel-by-channel definition of the standard values enabled (set to ON with
the [:SENSe]:CORRection:MULTiple:CKIT:STAN3[:STATe] command),
the standard values for the selected channel (selected with the
[:SENSe]:CORRection:MULTiple:CHANnel command) are set at execution
of the command.
Parameters
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
Query response {numeric 1},{numeric 2}<newline><^END>
Related commands [:SENSe]:CORRection:LOAD[:STATe] on page 242
[:SENSe]:CORRection:CKIT:STAN3:FORMat on page 236
[:SENSe]:CORRection:MULTiple[:STATe] on page 245
[:SENSe]:CORRection:MULTiple:CHANnel on page 243
[:SENSe]:CORRection:MULTiple:CKIT:STAN3[:STATe] on page 244
Equivalent key
sequence
[Meas Setup] - CORRECTION - REF- A|B
<numeric 1> <numeric 2>
Description Value of the primary parameter. Value of the secondary
parameter.
Range -999.999 to 999.999 -99.9999E9 to 99.9999E9
Initial value 100E-9 0
Unit F (farad) Depends on the type of
parameter.