Keysight E4981A - Calculate1:Math:state

190 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:CALCulate1:MATH:STATe
Syntax :CALCulate1:MATH:STATe {ON|OFF|1|0}
:CALCulate1:MATH:STATe?
Description Determines whether to use the function (deviation measurement mode) that
displays the primary parameter measurement result in deviation from the
reference value (set using the :DATA[:DATA] command).
Parameters
Query response {1|0}<newline><^END>
Related commands :CALCulate1:MATH:EXPRession:NAME on page 189
:CALCulate1:FORMat on page 188
:CALCulate2:FORMat on page 191
:CALCulate2:MATH:STATe on page 193
Equivalent key
sequence
[Meas Setup] - DEV A - OFF
Changing any of the measurement parameters will automatically disable
this function. To avoid this, you have to write a program so that this
command is executed after the execution of the measurement parameter
setup command (:CALCulate1:FORMat and :CALCulate2:FORMat).
Description
ON or 1 Enables the deviation measurement mode.
OFF or 0 (initial value) Disables the deviation measurement mode (in other
words, displays the measurement result in an absolute
value).