Keysight E4981A - Calculate1:Comparator:beeper:condition

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 173
Command Reference
E4981A SCPI Commands
:CALCulate1:COMParator:BEEPer:CONDition
Syntax :CALCulate1:COMParator:BEEPer:CONDition {FAIL|PASS}
:CALCulate1:COMParator:BEEPer:CONDition?
Description Sets the condition for producing a beep sound: when sorting with the
comparator fails (sorts into any BIN other than BIN1 to BIN9) or passes (sorts
into BIN1 to BIN9).
Parameters
Query response {FAIL|PASS}<newline><^END>
Related commands :SYSTem:BEEPer:STATe on page 273
:CALCulate1:COMParator:BEEPer[:STATe] on page 174
Equivalent key
sequence
[Meas Setup] - LIMIT TABLE - BEEP
Description
FAIL (initial value) Instructs the instrument to beep when the sorting fails.
PASS Instructs the instrument to beep when the sorting pass.