Keysight E4981A - Source:voltage[:Level][:Immediate][:Amplitude]

268 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]
Syntax :SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude] <numeric>[mV|V]
:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]?
Description Sets the measurement signal level.
Parameters
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
Query response {numeric}<newline><^END>
Equivalent key
sequence
[Meas Setup] - LEVEL
<numeric>
Description Measurement signal level
Range 100m to 1
Initial value 1
Unit V
Resolution 10m
A fraction below the resolution is rounded off. MAX or MIN can be used to
specify the parameters.