Keysight E4981A - Calibration:cable:correction:state

170 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:CALibration:CABLe:CORRection:STATe?
Syntax :CALibration:CABLe:CORRection:STATe? <numeric>
Description Gets cable correction ON/OFF. (Query Only)
Parameters
Query Response {1|0}<newline><^END>
Related commands :CALibration:CABLe:CORRection:CLEar on page 165
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:LOAD on
page 166
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:OPEN on
page 167
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:REFerence on
page 168
:CALibration:CABLe:CORRection:SAVE on page 169
Equivalent key
sequence
No equivalent key is available on the front panel.
<numeric>
Description Cable Length (in meters)
Range 1or 2
The value of this command is not changed with *RST and :SYSTem:PRESet
and is only changed with Factory Default reset (available only through
Front Panel).