Keysight E4981A - 4268, 4288 A Vs. E4981 A SCPI Command Correspondence Table

342 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Information for Replacing 4268A, 4288A with E4981A
4268, 4288A vs. E4981A SCPI Command Correspondence Table
-
4268, 4288A vs. E4981A SCPI Command Correspondence Table
Table B-1 (by function) and Table B-2 (by alphabetical order) provides
at-a-glance lists of SCPI commands correspondence between 4268A, 4288A
and E4981A.
Table B-1 At-a-glance SCPI command correspondence between 4268A, 4288A, and E4981A (by function)
Function Item to Be Set Up/Executed SCPI Command Note
E4981A 4268A 4288A
Measurement
condition
Reset :SYSTem:PRES
et
]]Correction
date is not
initialized for
4288A
*RST ]]
Measurement
parameter setup
Primary parameter :CALCulate1:F
ORMat
]]
Secondary parameter :CALCulate2:F
ORMat
]]
Measurement signal
setup
Frequency :SOURce:FREQ
uency[:CW]
]]
1 MHz frequency shift :SYSTem:FSHif
t
NA ]
Level :SOURce:VOLT
age[:LEVel][:I
MMediate][:A
MPLitude]
]]
Signal level compensation (SLC) :SOURce:VOLT
age:ALC[:STAT
e]
] NA ALC function is
not installed to
4288A
Output mode (Synchronous source) :SOURce:VOLT
age:MODE
] NA Signal
synchronizatio
n is not on
4288A
Measurement range
setup
AUTO [:SENSe][:FIM
Pedance]:RAN
Ge:AUTO
]]
Range [:SENSe][:FIM
Pedance]:RAN
Ge[:UPPer]
]]
Measurement time
mode setup
Conventional [:SENSe][:FIM
Pedance]:APE
Rture[:MODE]
]]
N [:SENSe][:FIM
Pedance]:APE
Rture:TIME
NA NA
Averaging setup ON/OFF [:SENSe]:AVER
age[:STATe]
]]
Number of Averaging [:SENSe]:AVER
age:COUNt
]]
Cable length setup :CALibration:C
ABLe
]]