224 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:FORMat:STATus:EXTension
Syntax :FORMat:STATus:EXTension {ON|OFF|1|0}
:FORMat:STATus:EXTension?
Description This command enables/disables the status extension reporting for Contact
check failure.
If the status reported (numeric1) from *TRG, :FETCh? and :READ? is 2
(Detection of LowC or No Contact), then :FORMat:STATus:EXTension can be
enabled to find the source of Contact Check failure. The return value of status
determines the source of contact check failure and are as follows:
• +8: Threshold1 Failure
• +16: Threshold2 Failure
• +128: Signal Level Check failure when LVL COMP = ON and Contact Check
= ON.
Parameter
Query response {1|0}<newline><^END>
Related commands *TRG on page 163
:FETCh? on page 220
:READ? on page 230
[:SENSe][:FIMPedance]:CONTact1:VERify[:STATe] on page 260
Equivalent key No equivalent key is available on the front panel.
Description
ON or 1 Enables the extended reporting of Contact Check Failure.
OFF or 0 Disables the extended reporting of Contact Check Failure.
To Next Page
Loading...
