Keysight E4981A - Trg; Tst; Wai

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 163
Command Reference
IEEE Common Commands
*TRG
Syntax *TRG
Description If the trigger source is set to BUS (set with the :TRIGger[:SEQ1]:SOURce
command), triggers the E4981A as it waits for a trigger and reads out the
measured data after the measurement is completed.
The transfer format of data read out with this command conforms to the setup
of the :FORMat[:DATA] command.
Query response It is the same as that of the :FETCh? command. For details, refer to the
description of :FETCh?.
Related commands :FETCh? on page 220
:TRIGger[:SEQ1]:SOURce on page 305
:FORMat[:DATA] on page 225
:READ? on page 230
:FORMat:STATus:EXTension on page 224
Equivalent key
sequence
[Trigger]
*TST?
Syntax *TST?
Description Does nothing. The self-test is not executed by this command in the case of the
E4981A. Always returns 0. (Query Only)
Equivalent key
sequence
No equivalent key is available on the front panel.
*WAI
Syntax *WAI
Description Waits until all commands sent before this command are executed. (No query)
Equivalent key
sequence
No equivalent key is available on the front panel.
Although this command does not have “?”, a query response is given.