Keysight E4981A - Data:points:buf2

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 203
Command Reference
E4981A SCPI Commands
:DATA:POINts:BUF2
Syntax :DATA:POINts:BUF2 <numeric>
:DATA:POINts:BUF2?
Description Specifies the size of data buffer 2 in number of measurements. Executing this
command returns the pointer to the specified data buffer (the location to feed
measurement data) back to the start.
Parameters
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric} <newline><^END>
Related commands :DATA:FEED:BUF2 on page 196
:DATA:FEED:CONTrol[:STATe] on page 200
Equivalent key
sequence
No equivalent key is available on the front panel.
The functionality of this command is same as :DATA:POINts[:DATA] with
value of BUF2.
<numeric>
Description Number of measurements for the data buffer specified with BUF2
Range 1 to 200
Initial value 200
Resolution 1