EasyManuals Logo

Keysight E4981A Programming Manual

Keysight E4981A
389 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #162 background imageLoading...
Page #162 background image
162 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
IEEE Common Commands
10-
*SRE
Syntax *SRE <numeric>
*SRE?
Description Sets the value of the Service Request Enable Register.
Parameters
If the specified parameter is out of the allowable setup range, “Out of range”
error is generated. Note that bit 6 cannot be set to 1.
Query response {numeric}<newline><^END>
Related commands *ESE on page 157
:STATus:OPERation:ENABle on page 270
Equivalent key
sequence
No equivalent key is available on the front panel.
*STB?
Syntax *STB?
Description Reads out the value of the Status Byte Register. (Query only)
Query response {numeric}<newline><^END>
Equivalent key
sequence
No equivalent key is available on the front panel.
<numeric>
Description Setup value of the register
Range 0 to 255
Initial value 0
Resolution 1

Table of Contents

Other manuals for Keysight E4981A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight E4981A and is the answer not in the manual?

Keysight E4981A Specifications

General IconGeneral
BrandKeysight
ModelE4981A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals