Keysight E4981A Programming Manual

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 201
Command Reference
E4981A SCPI Commands
:DATA:FEED[:SOURce]
Syntax :DATA:FEED[:SOURce] {BUF1|BUF2},{"CALCulate1"|"CALCulate2"|""}
:DATA:FEED[:SOURce]? {BUF1|BUF2}
Description Selects the measurement data fed into data buffer 1 or data buffer 2 from the
following: primary parameter, secondary parameter, or none to be fed. The
query response is a string with double quotation marks (“).
Parameters
Query response {"CALCulate1"|"CALCulate2"|""}<newline><^END>
Related commands :DATA:FEED:BUF1 on page 195
:DATA:POINts:BUF2 on page 203
Equivalent key
sequence
No equivalent key is available on the front panel.
Description
BUF1 Specifies data buffer 1, to which the
{“CALCulate1”|”CALCulate2”|””} setting is applied or reads out the
setup of data buffer 1.
BUF2 Specifies data buffer 2, to which the
{“CALCulate1”|”CALCulate2“|””} setting is applied or reads out the
setup of data buffer 2.
Description
“CALCulate1” Specifies the primary parameter as the measurement data fed into
the data buffer specified with {BUF1|BUF2}.
“CALCulate2” Specifies the secondary parameter as the measurement data fed
into the data buffer specified with {BUF1|BUF2}.
““ (initial value) Does not feed the measurement data into the data buffer specified
with {BUF1|BUF2}.

Keysight E4981A Specifications

General

Brand	Keysight
Model	E4981A
Category	Measuring Instruments
Language	English