Keysight E4981A - Device Selector; LAN Remote Control System; System Configuration

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 21
Overview of Remote Control
LAN Remote Control System
Device selector
The device selector is a unique value assigned to each device that is used by
the controller to select the control target (to send/receive messages) among
devices connected on the GPIB remote control system.
The device selector consists of a select code (usually, 7) and a GPIB address.
For example, when the select code is 7 and the GPIB address is 17, the device
selector is 717. The select code must be individually set for each system. The
GPIB address must be set to a unique value for each device, and is used to
identify devices on the same system. In the description and sample programs
in this manual, it is assumed that the device selector is set to 717.
Setting the GPIB address of the E4981A
[System] - SYSTEM CONFIG - GPIB ADDR
LAN Remote Control System
The LAN (Local Area Network) remote control system provides two methods:
controlling the E4981A using the SICL-LAN server and controlling the E4981A
using the telnet server.
System configuration
Use a LAN cable to connect the E4981A to the external controller (computer).
Figure 2-2 shows an overview of the LAN remote control system’s
configuration.
Figure 2-2 Configuration of the LAN remote control system
e4981aue0018
㪟㪜 㪮 㪣㪜 㪫 㪫
㪧㪘 㪚 㪢 㪘 㪩㪛
㪭㪼㪺㫋㫉㪸
㪋㪏 㪍 㪆㪍㪍 㪯 㪤
㪩㪜㪪㪜㪫
㪣㪘㪥
Agilent E4981A
L CUR
L POT
H POT
H CUR
UNKNOWN
Discharge test device before connecting
r10V Peak Max Output CAT I
rV Peak Max
SYNC CLK
In / Out
Trigger
Return
789
456
123
0
.
Preset
Display
Format
Meas
Setup
Recall A Recall B
Save/
Recall
System
Local/
Lock
㪠㪧㩷㪘㪻㪻㫉㪼㫊㫊
㪠㪧㩷㪘㪻㪻㫉㪼㫊㫊
㪠㪧㩷㪘㪻㪻㫉㪼㫊㫊
㪚㫆㫄㫇㫌㫋㪼㫉
㪦㫋㪿㪼㫉㩷㪠㫅㫊㫋㫉㫌㫄㪼㫅㫋㫊