Keysight E4981A - Obtaining, Checking, and Applying Correction Data

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 19
Overview of Remote Control
GPIB Remote Control System
GPIB Remote Control System
What is GPIB?
GPIB (General Purpose Interface Bus) is an interface standard for connecting
computers and peripherals that supports the following international standards:
IEEE 488.1, IEC-625, IEEE 488.2, and JIS-C1901. The GPIB interface allows
you to control the Keysight E4981A from an external computer. The computer
sends commands and instructions to the E4981A and receives data sent from
the E4981A via the GPIB.
System configuration
Use GPIB cables to make connections between the E4981A, the external
controller (computer), and peripherals. Figure 2-1 shows an overview of the
GPIB remote control system’s configuration.
Figure 2-1 Configuration of the GPIB remote control system
e4981aue0017
㪟㪜 㪮 㪣㪜 㪫 㪫
㪧㪘 㪚㪢㪘 㪩 㪛
㪭㪼㪺㫋㫉㪸
㪋㪏 㪍 㪆㪍㪍 㪯 㪤
㪩㪜㪪㪜㪫
㪎㪉㪈
㪎㪯㪯
㪎㪈㪎
㪞㪧㪠㪙
Agilent E4981A
L CUR
L POT
H POT
H CUR
UNKNOWN
Discharge test device before connecting
r10V Peak Max Output CAT I
rV Peak Max
SYNC CLK
In / Out
Trigger
Return
789
456
123
0
.
Preset
Display
Format
Meas
Setup
Recall A Recall B
Save/
Recall
System
Local/
Lock
㪪㪼㫃㪼㪺㫋㩷㪚㫆㪻㪼
㪞㪧㪠㪙㩷㪘㪻㪻㫉㪼㫊㫊
㪪㪼㫃㪼㪺㫋㩷㪚㫆㪻㪼
㪞㪧㪠㪙㩷㪘㪻㪻㫉㪼㫊㫊
㪪㪼㫃㪼㪺㫋㩷㪚㫆㪻㪼
㪞㪧㪠㪙㩷㪘㪻㪻㫉㪼㫊㫊
㪦㫋㪿㪼㫉㩷㪠㫅㫊㫋㫉㫌㫄㪼㫅㫋㫊
㪚㫆㫄㫇㫌㫋㪼㫉